blog di Aleks Stankovic

The first step was to create a new family type. But this time we didn't choose just the ‚metric generic model‘, but the ‚ metric generic model face based‘. 

Then we created (like the last time) first a child file. The steps were more or less the same: 

reference plane > extrusion > aligning and lock and give the square dimensions. 

After this I made another family tipe but there I choosed the normal ‚metric generic model‘.

The main subject of this lecture was the mass costumazation.

The first step was to open a family file, insert a reference plane, create an extrusion, and arrange the sides of the extrusion with the reference plane. The next step was the creation of the family file ‚mother‘:

We had to insert three reference planes that are useful for the design of the ‚mother‘ to be used as a base.

Then I assigned the parameters ‚m_height’, ‚m_length’ and ‚m_width’ as shared instance parameters to allow a change within the assembly file.

We created a family in a metric generic model.

The beginning was to draw two reference planes and the adding of a dimension between them (DI). We had to be sure that its metric, therefore the parametric Modell. 

The  next step was creating a rectangle (extrusion) and finish the exit mode. 

To lock the size of the rectangle to the given reference planes we aligned and locked them. Each one. After this we changed into elevation where we draw also reference plane. There we added the dimensions, aligned them and locked the rectangle sides.

1. Parametric

2. standardizzazione

3. individualized production

4. efficienza

5. design

6. futuro

7. forma

8. innovazione

9. cooperazione

10. dinamismo